Adafruit Trinket M0

$12.95

  • ATSAMD21E18 32-bit Cortex M0+
  • 256KB Flash – 32x as much as 8 KB on ATtiny85
  • 32 KB RAM – 64x as much as 512 bytes on ATtiny85
  • 48 MHz 32 bit processor – 6x as fast as ATtiny85 (not even taking into account 32-bit speedups)
  • Can be used in Arduino or CircuitPython as USB serial console, Keyboard/Mouse HID, even a little disk drive for storing Python scripts.
  • Built in green ON LED
  • Built in red pin #13 LED
  • Built in RGB DotStar LED
  • All 5 GPIO pins are available and are not shared with USB

Quick Start Guide:
https://learn.adafruit.com/adafruit-trinket-m0-circuitpython-arduino/circuitpython

Out of stock

SKU: Trinket_M0 Category:

Description

 

  • ATSAMD21E18 32-bit Cortex M0+
  • 256KB Flash – 32x as much as 8 KB on ATtiny85
  • 32 KB RAM – 64x as much as 512 bytes on ATtiny85
  • 48 MHz 32 bit processor – 6x as fast as ATtiny85 (not even taking into account 32-bit speedups)
  • Native USB supported by every OS – can be used in Arduino or CircuitPython as USB serial console, Keyboard/Mouse HID, even a little disk drive for storing Python scripts.
  • Can be used with Arduino IDE or CircuitPython
  • Built in green ON LED
  • Built in red pin #13 LED
  • Built in RGB DotStar LED
  • All 5 GPIO pins are available and are not shared with USB – so you can use them for whatever you like!
    • Five GPIO pins with digital input/output with internally connected pullups or pulldowns
    • Three of the I/O pins can be used for 12-bit analog input
    • True analog output on one I/O pin – can be used to play 10-bit quality audio clips
    • We gave the M0 pads the exact same names as the original Trinket so all your existing Arduino code will work exactly the same as-is without changes
    • Two high speed PWM outputs – for servos, LEDs, etc
    • Three pins can also be used as hardware capacitive touch sensors with no additional components required
    • Can drive NeoPixels or DotStars on any pins, with enough memory to drive 8000+ pixels. DMA-NeoPixel support on one pin so you can drive pixels without having to spend any processor time on it.
    • Native hardware SPI, I2C and Serial available on two pads so you can connect to any I2C or Serial device with true hardware support (no annoying bit-banging). You can have either one SPI device or both I2C and Serial.
  • Same Reset switch for starting your project code over
  • Power with either USB or external output (such as a battery) – it’ll automatically switch over
  • Mounting holes

 

Additional information

Weight .02 oz
Dimensions 4 × 6 × .3 in

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…